Asl States - Precor Experience Series Service Manual

Error code operation: A logged system error code will cause the ASL to begin pulsing
l
yellow. If the error self-corrects, the ASL will change from pulsing to solid yellow.
Depending on the error code type, after the end of a workout, the solid yellow light will
either revert back to a steady or pulsing blue, or it might require manually resetting the
light from the service menu.
Maintenance counter operation: The counter starts at 250 hours and counts down the
l
hours of active use to 0 hours. When the counter reaches zero, the ASL will begin
pulsing blue indicating preventative maintenance is due.

ASL States

The ASL utilizes a combination of blue and yellow lights to indicate the current operational
machine status.
ASL State
OFF The unit is powered OFF or there is no power to the LPCA or some
other hard failure. On P10, P30, P30i and P31 consoles the ASL bright-
ness is set to OFF.
Blue Solid Normal operation Indicates that the ASL has not detected any logged
error codes.
Blue Pulsing Preventative maintenance reminder.
Treadmills: A belt rating of 0 or 1 will cause a blue pulsing ASL light
indicating that there is a problem with the running belt/deck and is in
need of servicing or replacement.
Ellipticals: The maintenance counter starts at 1000 hours and counts
down the active use hours to 0. When the counter reaches zero hours,
the ASL will begin pulsing blue indicating preventative maintenance is
due.
Yellow Solid Indicates an error has occurred, was self-corrected and the machine
can be used. The fault can be cleared.
Yellow Pulsing There is a current non-recoverable fault condition, there is a loss of a
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
DESCRIPTION
7 Troubleshooting
Active Status Light "ASL"
Page 189