Precor Experience Series Service Manual page 159

1. If the Outer pivot shaft set screw was removed, reinstall a new Outer Nylock set
screw. Torque
2. Reinstall the Moving Arm Pivot Shaft into the pivot shaft mounting bar. Make sure the
Outer set screw fits into the pivot shaft locking cutout.
3. Reinstall the 3/16" hex key pivot shaft Inner pivot shaft set screw. Fully tighten and
torque to 300 in-lbs (34 Nm).
CAUTION: Do not reuse the inner or outer Nylock patch set screws for install-
ation. Either removing or loosening the Nylock set screw will compromise the
integrity of the Nylock patch. Discard and order new set screws for installation
(see "Parts" on
4. Reinstall the side cover Retention Block and secure using the two #3 Phillips screws.
1
Torque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut
example: 5 NM torque is equivalent to 5 newton's of force applied one meter from the center
of the bolt, 6 ft-lb is equivalent to 6 lbs of force applied 1 foot away from the center of the
bolt.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
to 300 in-lbs (34 Nm).
page 204, bubble # 252).
6 Replacement Procedures
Moving Arms Replacement
Page 150