Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the Drive Access panel, see
2. Remove the right and left Drive Disk coves, see
3. Remove the right Stairarm, see
4. Use a 1/2" socket to loosen the two Generator/Eddy Brake assembly and the two
Drive Components assembly carriage bolt nuts (left side). Loosen the nuts just
enough to allow movement but keep the carriage bolt heads inserted into the adjust-
ment slots. Do not remove the fastener nuts.
5. Use a 1/2" socket to loosen the first stage belt tensioner and walk the first stage drive
belt off the input drive and smaller Step-up Pulley/Tensioner assembly pulleys.
Remove the first stage drive belt.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Second Stage Drive Belt Replacement
"" on
page 78.
" > " on
"Stairarm Replacement" on
6 Replacement Procedures
page 80.
page 152.
Page 101