Precor Experience Series Service Manual page 90

Repeat this procedure for both the right and left Drive Disk coves.
1. Remove the Drive Access panel, see
2. Rotate the crank until the upper Drive Disk cover attachment screws can be seen
through the drive cover fastener cutout. Then use a #2 Phillips screwdriver to remove
the screw. Then slowly move the Input Crank upward until the second screw can be
seen and remove if installed (there may only be one Drive Disk cover attachment
screw installed. However, two screws are required for installation, order any missing
screws.). Retain part(s) and/or fastener(s) for installation.
Note: Some early production units were shipped with only one disk cover crank
attachment screw. When reinstalling the disk cover, order two additional screws
and use two crank attachment crews per disk cover, see
bubble # 155.
IMPORTANT: Take your time when removing the drive disk mounting screws. The
access area is small and it is very easy to accidentally drop the screws down into
the drive housing area. If this happens, the drive covers will need to be removed to
retrieve the screw.
3. Use your hand to lightly strike the inside of the drive disk to unsnap the disk from the
three latch catch pins and remove. Rotate the drive disk to position one of the three
latch catch pins at the rear of the housing and then use your hand to strike the inside
of the drive disk to unsnap the disk from the latch catch pin, Repeat for the two remain-
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Covers and Panels Replacement
"" on page 78.
6 Replacement Procedures
"Parts" on page 204,
Page 81