Precor Experience Series Service Manual page 92

2. Rotate the crank until one of the two Drive Disk cove attachment screw holes can be
seen through the drive cover fastener cutout. Then install the #2 Phillips screw and
fully tighten. Move the crank to the second attachment screw hole and install the
second screw. If the second screw is missing, order a new screw and install (two
fastener screws (two per side are required), see
Note: Some early production units were shipped with only one disk cover attach-
ment screw. Two cover crank fasteners are now required. If missing screws, order
additional screw, see
1. Reinstall the Drive Access panel, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Parts" on page 204, bubble #155.
"" on page 78.
6 Replacement Procedures
Covers and Panels Replacement
"Parts" on page 204, bubble #155.
Page 83