Precor Experience Series Service Manual page 104

3. Disconnect the negative battery cable (black terminal) and then the positive battery
cable (red terminal).
4. If installed, cut the zip tie.
5. Remove the battery.
Installation Instructions
1. Reconnect the positive cable to the positive terminal (red) and then the negative bat-
tery cable to the negative terminal (black).
2. Reinstall the battery and secure with a cable zip tie.
3. Connect the positive cable to the battery red terminal. Make sure the positive cable
remains securely connected thru the inline fuse to the LPCA board.
4. Connect the negative cable to the battery black terminal. Make sure the negative wire
remains securely connected to the frame weldment.
5. Reinstall the LPCA/Battery module cover using the one #2 Phillips screw.
6. Reinstall the left Drive Disk cove, see
7. Verify operation and return to service, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
" > " on page 80.
"Operation Verification" on
6 Replacement Procedures
Battery Replacement
page 19.
Page 95