Precor Experience Series Service Manual page 29

1. Access the Service menu (51765761) and perform the following console System
Tests (Settings > System Settings > System Tests):
Touchscreen Calibration: Follow screen prompts to complete test. When
l
the test is completed the console will automatically exit and return to the
System Tests menu.
Touchscreen Test: Verify that there is a trace created that follows your fin-
l
ger movement across the touchscreen surface. Select Finish to exit. move
your finger and verify that a trace follows
Backlight Test: Tests the display backlight brightness. Follow prompts to
l
complete test.
RGB Test: Touch the screen to cycle through the test colors: Red, Green,
l
Blue, White, & Black. Returns to the System Tests menu when completed.
Numeric Backlight Test: Tests the controls numeric display brightness.
l
Returns to the System Tests menu when completed.
Numeric Display Test: Tests the controls numeric display. Returns to the
l
System Tests menu.
2. Exit the Diagnostic Test menu. (press Back to exit & return to the banner screen)
Machine Operation Test
This test verifies the console motion controls, metric indicators and machine operation:
1. Select QUICKSTART to begin a manual workout. Do this test while pedaling and
the INCLINE set to 0% incline:
2. Operate the RESISTANCE motion control from minimum to maximum range
while verifying the machine operation:
During the operation of this test, make sure that the pedal stairarms, mov-
l
ing arms (moving arm models only) an input drive are operating smoothly
and that there are no unusual noises.
Make sure that the console RESISTANCE paddle control operation is
l
smooth and working correctly.
Vary the RESISTANCE from minimum to maximum and back to minimum
l
while pedaling, verify that the pedal resistance increases and decreases as
expected.
Verify that there were no unusual noises during this test.
l
Verify that the console RESISTANCE indicators and workout displays are
l
showing correct information.
3. On machines with the adjustable CrossRamp, While pedaling operate the
INCLINE motion control from minimum to maximum levels. Verify the following
machine operation criteria.
During the operation of this test, make sure that the pedal stairarms, mov-
l
ing arms (moving arm models only) an input drive are operating smoothly
and that there are no unusual noises.
Make sure that the console INCLINE paddle control operation is smooth
l
and working correctly.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
3 Operation Verification
Operation Verification Tests
Page 20