Precor Experience Series Service Manual page 134

6. Tension the first stage drive belt, see
page 52.
7. Tension the second stage drive belt, see
ment" on page 56.
8. Tighten the two Generator/Eddy Brake assembly and two Drive Components
assembly carriage bolt fasteners, torque to 180 in-lbs (20.3 Nm).
9. Reconnect the Generator input cable (J1) and Eddy/Brake load cable (J7) on the
LPCA board. Reinstall the LPCA/Battery module cover and secure with the #2 Phillips
screw fastener.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Drive Components assembly Replacement
"First Stage Drive Belt Tension Adjustment" on
"Second Stage Drive Belt Tension Adjust-
6 Replacement Procedures
Page 125