Precor Experience Series Service Manual page 157

1. Remove the front top cover, see
2. Remove the two #3 Phillips side cover Retention Bracket screws and remove.
1. Disconnect the Linkarm from the Moving Arm:
a. Remove the #2 Phillips Outer Linkarm cover mounting screw and remove. .
Retain part(s) and/or fastener(s) for installation.
b. Loosen the 9/16" Linkarm hex head mounting bolt and remove the Linkarm
from the Moving Arm. Retain part(s) and/or fastener(s) for installation.
c. Remove the Inner Linkarm cover from the Moving Arm. Retain part(s) and/or
fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"" on page 64.
6 Replacement Procedures
Moving Arms Replacement
Page 148