for installation.
b. Remove the two 5/16" hex head bolts. Retain part(s) and/or fastener(s) for
installation.
c. Use external 0.047" retaining ring pliers to remove the Stairarm Pivot Block
retaining ring. Retain part(s) and/or fastener(s) for installation.
d. Remove the Stairarm off the Crank Spindle and carefully lay on the floor.
e. Remove the Inner Pivot Block cover
f. Remove the Pivot Block flat washer and wave washer off the Crank Spindle.
Note that the wave washer sets against the Crank. Retain part(s) and/or
fastener(s) for installation.
3. Remove the Stairarm from the ramp. Roll the wheels down the track and off the back
of the ramp.
Installation
Installing the Stairarm onto the Input Crank
1. Reinstall the Stairarm onto the ramp. Carefully place the stairarm wheel onto the back
of the ramp track and then roll the wheel up the ramp.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Stairarm Replacement
Page 159