Precor Experience Series Service Manual page 126

7. Use a 1/2" socket to remove the two carriage bolt fasteners to separate the Gen-
erator/Eddy Brake assembly from the Step-up Pulley/Tensioner Assembly.
Installation Instructions
1. Place the Generator/Brake assembly onto the Step-up pulley/Tensioner assembly.
Secure using the two carriage bolts and nuts. Tighten the bolts just enough to keep
the carriage bolt heads inserted into the bolt belt adjustment slots to allow movement.
Do not fully tighten.
2. Use a 1/2" socket to install the second stage belt tension hardware: the tensioner
adjustment bolt, washer, and tug plate. Tighten the tensioner bolt just enough to keep
the tensioner hardware in place.
3. Reinstall the second stage drive belt by walking the belt onto the larger Step-up Pul-
ley/Tensioner pulley and Generator/Brake assembly pulley. Tighten the tensioner
bolts just enough to keep the belt on the pulleys and tensioner hardware in place. Do
not fully tension or over tension the belt.
4. Reinstall the Drive Components assembly, see
Replacement" on
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
page 119.
6 Replacement Procedures
Step-up Pulley/Tensioner Assembly Replacement
"Drive Components assembly
Page 117