Precor Experience Series Service Manual page 167

1. Remove the Linkarm from the Stairarm (moving arm models only):
a. Remove the #2 Phillips screw fastener and remove the Outer Linkarm Cover.
Retain part(s) and/or fastener(s) for installation.
b. Remove the 9/16" hex head screw and remove the Linkarm from the Stairarm
Linkarm mount and carefully lay onto the floor.
c. Remove the Inner Linkarm cover and Linkarm Transition cover from the Stair-
arm Linkarm mount. Retain hardware and fastener for installation.
Removing the Stairarm from the Input Drive Crank
2. Remove the Stairarm from the Input Drive Crank:
a. Remove the #2 Phillips screw fastener and slide the Outer Pivot Block cover
rearward and away from the frame to remove. Retain part(s) and/or fastener(s)
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Stairarm Replacement
Page 158