c. Then use the crank to rotate the input pulley a couple of rotations to seat the
belt and remeasure the belt tension.
d. If the belt tension is not within specification, repeat the tension adjustment pro-
cess until the belt tension is correctly tensioned.
8. Use a 1/2" socket to fully tighten the two Generator/ Eddy Brake Assembly carriage
bolts (left side), torque bolts to 180 in-lbs (20.3 Nm).
9. Reinstall the left Drive Disk cove, see
10. Reinstall the Drive Access Panel, see
11. Verify machine operation and return to service, see
page 19.
See Also
"First Stage Drive Belt Tension Adjustment" on page 52
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Second Stage Drive Belt Tension Adjustment
" > " on
page 80.
"" on
page 78.
"Operation Verification" on
5 Adjustment Procedures
Page 59