Videos; Procedure - Precor Experience Series Service Manual

Videos

EFX600/700/800 Dual Stage Input Drive
Belt Tension Verification

Procedure

Review entire procedure before starting.
IMPORTANT: Adjust the first stage drive belt tension prior to adjusting the second
stage drive belt tension.
1. Remove the Drive Access Panel, see
2. Remove the left Drive Disk cove, see
3. Use a 1/2" socket to loosen the two first stage Drive Components assembly carriage
bolt nuts (left side) just enough to allow assembly movement. Do not remove the car-
riage bolt nuts.
CAUTION: Make sure that the two Drive Components assembly bolts are
loosened before adjusting the first stage belt tensioner. The tensioner hardware
can be damaged and the belt cannot be tensioned if the Drive Components
assembly bolts are not loosened.
4. Place the belt tension gauge onto the first stage drive belt midway between the Input
Drive pulley and smaller Step-up Assembly pulley and measure the tension. Record
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Service Video
"" on
" > " on
5 Adjustment Procedures
First Stage Drive Belt Tension Adjustment
Link
EFX600/700/800 Dual Stage Input
Drive Belt Tension Verification
page 78.
page 80.
Page 53