Precor Experience Series Service Manual page 150

Installation Instructions
1. If removed, reinstall the AC Adapter (J4) cable
2. Reinstall the LPCA board using the two #2 Phillips screw fasteners.
3. Reconnect the following LPCA interface cables:
a. Reconnect the Battery (J9) cable
b. Reconnect the Comm Serial (J2) cable
c. Reconnect the Active Status Light (J12) cable
d. Reconnect the Generator (J1) cable
e. Reconnect the Eddy/Brake (J7) cable
4. Reconnect the Positive (Red) and Negative (Black) battery terminal cables.
5. Reinstall the LPCA/Battery module cover using the one #2 Phillips screw fastener.
6. Reinstall the Left Drive Disk cover, see
7. Verify operation and return to service, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
LPCA (Lower PCA) Board Replacement
.
.
.
.
.
.
" > " on page 80.
"Operation Verification" on
6 Replacement Procedures
page 19.
Page 141