Table of Contents
Advertisement
Mounting and electrical connection
3
Mounting and electrical connection
DANGER!
Electric shock when live parts are touched.
Electric shocks can be fatal.
Before carrying out work on the device or load, disengage all the corresponding cir-
cuit breakers. Cover up live parts in the working environment.
Mounting the device
–
Enter or scan the device certificate and add it to the project. A high resolution
camera should be used to scan the QR code.
–
The device certificate should be removed from the device during mounting.
–
Document all passwords and keep them safe.
Observe ambient temperature. Ensure adequate cooling.
￭
Mount device on DIN rail.
Connecting the device
Connect either AC 230 V or AC 24 V valve drives to all the outputs.
Only connect valve drives with the same characteristics to each output (deenergised
closed/opened).
Do not connect any other loads.
Connect valve drives for frost-sensitive rooms to outputs A1 and A4. These are
switched off last in the event of overload.
Do not exceed maximum number of valve drives per output (siehe Kapitel "Technical
}
data"
Page 11).
Observe the technical data of the valve drives used.
Do not connect the neutral conductor from the output terminals through to additional
devices.
￭
Connect AC 230 V valve drives according to the connection diagram
(see figure 2).
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
Page 13 of 257
Advertisement
Table of Contents
