Table of Contents
Advertisement
Room temperature controller | Scenes
With overflow
The extended scene recall can take place with or without an overflow at the scene
limits. An overflow occurs when the last scene of the selected configuration is
reached when counting up or scene 1 when counting down and an additional tele-
gram in the last counting direction is received by the actuator.
Parameter activated: After reaching the last scene of the selected configuration, a
further ON telegram of the overflow is executed and scene 1 is recalled. Similarly,
after reaching scene 1, the overflow is executed by further OFF telegram and the
last scene of the selected configuration is recalled.
Parameter deactivated: A scene overflow is not possible. After reaching the last
scene of the selected configuration, further ON telegrams of the extended scene re-
call are ignored. In the same way, the actuator ignores further OFF telegrams if
scene 1 was recalled last.
This parameter is only visible when the extended scene recall is used.
Scene configuration
The scene configuration selected here decides whether the number of scenes is
either variable (1 ... 64) or alternatively fixed to the maximum (64).
variable (1...64 scenes): With this setting, the number of scenes used can be selec-
ted anywhere in the range 1 to 64. The parameter "Number of scenes" decides how
many scenes are visible for the switching output in the ETS and can therefore be
used. It is possible to specify which scene number (1 ... 64) controls each scene.
fixed (64 scenes): With this setting, all scenes are always visible and can therefore
be used. The scenes are controlled via permanently assigned scene numbers (1 ...
64) (scene number 1 -> scene 1, scene number 2 -> scene 2 ...). If necessary, indi-
vidual scenes can be deactivated.
Number of scene assignments
This parameter defines how many scenes are visible for the room temperature con-
troller in the ETS and can therefore be used.
Scene number
It is possible to preset which scene number (1 ... 64) controls each scene.
A setting of "0" deactivates the corresponding scene so that neither recalling nor
storage is possible. If the same scene number is configured for several scenes, only
the scene with the lowest sequential number will be addressed. The other scenes
will be ignored in this case.
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
Checkbox (yes / no)
variable (1...64 scenes)
fixed (64 scenes)
1...10...64
0...1*...64
*: The predefined scene number is de-
pendent on the scene (1...64).
Page 211 of 257
Advertisement
Table of Contents
