Status Indication - Gira KNX 2139 00 Product Documentation

Operation and indication | ETS configuration
￭ Activate the parameter "Disable bus control of individual outputs" on the para-
meter page "Manual operation".
The function for disabling the bus control is enabled and can be activated loc-
ally. Alternatively, deactivating the parameter prevents disabling of the bus
control from being activated in permanent manual operation mode.
The disabling initiated locally has the highest priority. Thus all other functions
of the actuator that can be activated via KNX (e.g. forced position, valve rins-
ing or service operation) are overridden. The bus-disabled output remains in
the state last set in permanent manual operation mode.
Depending on the configuration of the actuator in the ETS, the groups will be
set to the state most recently set or internally tracked after the disabling and
subsequent deactivation of permanent manual operation mode.
The disabling function of manual operation does not influence bus-disabled
outputs.
A failure of the bus voltage or an ETS programming operation deactivates dis-
abling of the bus control.

8.2.2 Status indication

The status LEDs on the front of the device can indicate the current status of the out-
puts permanently or temporarily.
– Continuous status indication:
The parameter "Indicate status temporarily" on the "Status indication" para-
meter page is deactivated. In the case of a continuous status indication, the
status LEDs always indicate the current status of the outputs.
– Temporary status indication:
The parameter "Indicate status temporarily" on the "Status indication" para-
meter page is activated. During temporary indication, the status indication is
activated by pressing the "Manual operation" button. The display length is set
in the ETS.
If manual operation is enabled in the ETS, pressing the "Manual operation"
button also activates the temporary or permanent manual operation mode.
The status indication always remains active during manual operation. At the
end of manual operation mode, the display length of the temporary status in-
dication is restarted. The status LEDs then go out after the configured time
has elapsed.
If manual operation is not enabled in the ETS, all status LEDs only show the
status of the outputs when the "Manual operation" button is pressed, depend-
ing on the duration of the display.
In the as-delivered state, the continuous status indication is preset.
If the parameter "Control via object" is activated, the "Temporary status indication"
communication object is available in the ETS. This object is bidirectional and can
firstly signal the status of the temporary status indication, and secondly, activate the
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100 Page 31 of 257