Gira KNX 2139 00 Product Documentation page 27

Operation and indication | Button operation and indication functions
The status LED of the selected output A1...A6 flashes. The two status LEDs
OPEN and CLOSE show the current status of the selected output.
￭ Press the OPEN and CLOSE buttons simultaneously for at least 5 seconds.
The selected valve output is disabled (activation via the bus no longer pos-
sible). The status LED of the disabled output flashes quickly and constantly
(even with manual operation deactivated).
An output that has been disabled in manual operation can thereafter only be
operated in permanent manual operation mode.
Cancelling the disabling of bus control of individual outputs via manual
operation
The device is in permanent manual operation mode.
Bus control of a valve output has been disabled previously in permanent manual op-
eration mode.
￭ Press the ǃ button briefly as many times as necessary until the desired out-
put is selected.
The status LED of the selected output A1...A6 flashes quickly. The two status
LEDs OPEN and CLOSE show the current status of the selected output.
￭ Press the OPEN and CLOSE buttons simultaneously for at least 5 seconds.
Selected output is enabled.
The selected valve output is re-enabled (activation via the bus is possible
again after manual operation has been deactivated).
The status LED of the enabled output flashes slowly.
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100 Page 27 of 257