Table of Contents
Advertisement
Operation and indication | Operation and indication parameters
Indicating status temporarily
The status LEDs on the front of the device can indicate the current status of the out-
puts permanently or temporarily.
Parameter deactivated: Continuous status indication. In this case, the status LEDs
always indicate the current status of the outputs.
Parameter activated: Temporary status indication. In this case, the status indication
is activated by pressing the "Manual operation" button. The display length is set in
the ETS. If manual operation is enabled in the ETS, pressing the "Manual operation"
button also activates the temporary or permanent manual operation mode. The
status indication always remains active during manual operation. At the end of
manual operation mode, the display length of the temporary status indication is re-
started. The status LEDs then go out after the configured time has elapsed.
Display length
This parameter defines the display length if the temporary status indication is activ-
ated.
Control via object
If the parameter "Control via object" is activated, the "Temporary status indication"
communication object is available in the ETS. This object is bidirectional and can
firstly signal the status of the temporary status indication, and secondly, activate the
status display. If a temporary status indication has been activated by pressing the
"Manual operation" button, the object transmits the value "ON". If the object receives
a telegram with the value "OFF" or "ON", the status LEDs indicate the status of the
outputs according to the display length. Manual operation is not activated in this
case.
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
Checkbox (yes / no)
6 ... 10 ... 255 s
Checkbox (yes / no)
Page 35 of 257
Advertisement
Table of Contents
