Table of Contents
Advertisement
Logic functions | Disabling element [Filtering/Time]
11.4.1 Disabling element parameters
Logic functions -> Logic function...
Time function
This parameter defines whether ON or OFF telegrams or both states are evaluated
with a delay after reception at the input. If a delay is provided, the delay time can be
configured separately for ON and OFF telegrams. If no delay is configured, the input
telegrams go directly into the filter.
Delay for ON telegrams
Minutes (0...59)
The delay for ON telegrams is configured here. A delay is only effective if the delay
time is set to greater than "0". Each ON telegram received at the input re-triggers the
delay time.
Special feature when using the delays: If no telegram is received at the input, a con-
figured delay time (time > 0) acts like an automatic cyclic trigger of the filter. The
most recently received input status is then forwarded to the filter automatically and
repeatedly after the delay has elapsed. This then works according to its configura-
tion and forwards the result to the output of the disabling element. Consequently, the
output then also transmits telegrams depending on the transmission criteria set. If
the cyclical transmission of the output is not desired due to the automatic triggering
of the filter, the transmission criterion should be set to "only transmit if the output
changes".
After bus voltage return or after an ETS programming operation, the delays are
triggered automatically.
Setting the ON delay time minutes.
Seconds (0...59)
Setting the seconds of the ON delay time.
The parameters for the ON delay are only available if the parameter "Time function"
is set to "only delay ON telegrams" or "delay ON and OFF telegrams".
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
no delay
Delay only ON telegrams
Delay only OFF telegrams
Delay ON and OFF telegrams
0...59
0...10...59
Page 229 of 257
Advertisement
Table of Contents
