Table of Contents
Advertisement
Valve outputs | Valve output - General
Transmit after bus voltage return
The object for the transmission of a failure of the valve operating voltage can actively
transmit the feedback information after a bus voltage return and an ETS program-
ming operation. This parameter specifies whether active telegram transmission
should take place after a device reset or not.
It is only visible with the status message activated.
Delay after bus voltage return
The feedback "Failure of operating voltage" will be transmitted to the bus after bus
voltage return or after an ETS programming operation. In these cases, the feedback
can be time-delayed with the time delay being preset globally for all device feedback
together on the "General" parameter page.
This parameter is only visible if the signal function is enabled and transmission after
bus voltage return is enabled.
no: The feedback "Failure of operating voltage" is transmitted immediately after bus /
mains voltage return or after an ETS programming operation.
yes: The feedback "Failure of operating voltage" will be transmitted with a delay after
bus voltage return or after an ETS programming operation. No feedback is transmit-
ted during a running time delay, even if the state changes.
Cyclical transmission
The signal telegram "Failure of operating voltage" can be transmitted cyclically,
should the actuator determine a failed valve operating voltage. This parameter spe-
cifies whether cyclical telegram transmission should take place or not. If the valve
operating voltage exists, then transmission is generally not cyclical.
This parameter is only visible with the status message activated.
9.3.6.2 Objects for valve voltage status
Function: monitoring of the valve operating voltage
Object no.
5
1-bit output object to signal a failure of the operating voltage (AC 24 V or AC 230 V)
of the valve outputs. The telegram polarity can be configured.
9.4
Valve output - General
9.4.1 Name
Optional names can be assigned for each valve output. The names should clarify the
use of the output (e.g. "living room floor"). The names are only used in the ETS in the
text of the parameter pages and communication objects.
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
Function
Failure of operating
voltage - Status
no / yes
no / yes
no / yes
Name
General valve out-
puts - Output
Type
DPT
Flag
1-bit
1,005
C, R, -, T, -
Page 63 of 257
Advertisement
Table of Contents
