Table of Contents
Advertisement
Room temperature controller | Room temperature measurement
Cycle time
Presetting of the monitoring time hours and minutes.
Cyclical polling of the temperature values Checkbox (yes / no)
This setting determines whether the controller polls the temperature value(s) cyclic-
ally. In the "no" setting, the temperature value is not automatically polled by the con-
troller. In this case the communication partner (e.g. controller extension) must trans-
mit its temperature value itself.
Cycle time
The polling time for the external temperature value(s) is specified here.
Temperature calibration
Adjust temperature input 1 by
Specifies the value by which the room temperature measured value of the first ex-
ternal KNX temperature sensor is adjusted.
Adjust temperature input 2 by
Specifies the value by which the room temperature measured value of the second
external KNX temperature sensor is adjusted.
Room temperature transmission behaviour
On change by (0 = inactive)
This parameter specifies the temperature value by which the actual value has to
change in order to have the actual temperature value transmitted automatically via
the object. The "0" setting deactivates the automatic transmission of the actual tem-
perature.
Cyclical (0 = inactive)
This parameter specifies whether and when the determined room temperature is
output cyclically via the "Actual temperature" object.
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
0 ... 4 h
1 ... 20 ... 59 min
1 ... 10... 255
-12.8...0...12.7 K
-12.8...0...12.7 K
0...0.5...25.5 K
0...15...255 min
Page 186 of 257
Advertisement
Table of Contents
