Gira KNX 2139 00 Product Documentation page 157

Room temperature controller | Operating mode and setpoints
Maximum shift downwards
This is used to define the maximum range in which the basic setpoint temperature
can be adjusted downwards.
This parameter is only visible with relative setpoint presetting!
Type of shift
Depending on the setting of the parameter "Type of shift", the shift takes place via a
2-byte communication object (acc. to KNX DPT 9.002) or via a 1-byte communica-
tion object (acc. to KNX DPT 6.010).
This parameter is only visible with relative setpoint presetting!
Accept changes permanently via bus
In addition to specifying individual setpoint temperatures by the ETS or basic set-
point object, the user can shift the basic setpoint in a specific range using the sensor
buttons or a communication object. Whether a basic setpoint shifting only affects the
currently active operating mode or whether it influences all other setpoint temperat-
ures of the remaining operating modes is determined by this parameter.
In the "yes" setting, the shift of the basic setpoint carried out affects all operating
modes. The shift is maintained even after a switchover of the operating mode or the
heating/cooling mode or adjusting the basic setpoint.
In the "no" setting, the basic setpoint shift carried out is in effect for only as long as
the operating mode or heating/cooling mode has not changed or the basic setpoint is
maintained. Otherwise the setpoint shift will be reset to "0".
Heating actuator 6-gang with controller | Order no. 2139 00 | 21393100
0 K
- 1 K
- 2 K
- 3 K
- 4 K
- 5 K
- 6 K
- 7 K
- 8 K
- 9 K
- 10 K
Via counter value x step width
Via relative temperature value
Checkbox (yes / no)
Page 157 of 257