Default-Metric (Ospf); Distance Ospf - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.6.21.1 no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Format
Mode

14.6.22 default-metric (OSPF)

This command is used to set a default for the metric of distributed routes.
Format
Mode
14.6.22.1 no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
Mode

14.6.23 distance ospf

This command sets the route preference value of OSPF in the router. Lower route
preference values are preferred when determining the best route. The type of OSPF can be
intra, inter, type-1, or type-2. The OSPF specification (RFC 2328) requires that
preferences must be given to the routes learned via OSPF in the following order: intra <
inter < type-1 < type-2. The <
Default
Format
Mode
14.6.23.1 no distance ospf
This command sets the default route preference value of OSPF in the router.
Format
Mode
14-40
no default-information originate [metric] [metric-
type]
Router OSPF Config
default-metric <1-16777215>
Router OSPF Config
no default-metric
Router OSPF Config
> range is 1 to 255.
preference
intra - 8; inter - 10; type-1, 13; type-2, 50.
distance ospf {intra | inter | type1 | type2}
<preference>
Router OSPF Config
no distance ospf {intra | inter | type1 | type2}
Router OSPF Config
v3.0, January 2008
Routing Commands