Xerox WorkCentre 4150 Service Manual page 272

REP 5.19 DADF Drive Roll Motor Assembly (4265)
Parts List on PL 5.60
Removal
NOTE: This procedure should only be performed on the 4265 machine. For the 4150 proce-
dure, refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not allow the optics cavity to become contaminated. Contamination of the optics cavity can
cause image quality defects.
1. Power off the machine. Disconnect the power cord.
2. Remove the DADF (REP 5.3).
WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
WARNING
CAUTION
3. Dislocate the DADF Rear Cover
1
Set the DADF on its side, with the rear of the DADF facing upwards.
2
Remove the screw.
Figure 1 Dislocating the DADF Rear Cover
January 2016
4-71
(Figure 1).
3
Carefully dislocate the
three locking tabs using a
flat-blade screwdriver.
4
Set the DADF down on
the table top, with the top
side facing upwards.
Repairs and Adjustments
REP 5.19