Xerox WorkCentre 4150 Service Manual page 136

09-100 Toner Low RAP
09-100 The machine has detected that the toner cartridge is almost empty.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. No immediate action is necessary. Ensure that a replacement toner cartridge,
Item 2 is in stock.
NOTE: The toner low message is based on a pixel count, not a signal from a sensor. It
cannot be reset by shaking the toner cartridge.
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
09-200 Toner Empty RAP
09-200 The machine has detected that the toner cartridge is empty.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
PL 9.10 Go to the relevant procedure:
• 4150 Checkout
• 4250/4260 Checkout
• 4265 Checkout
4150 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the
PWB PJ location illustration.
NOTE: The side cover assembly interlock switch must be closed to supply +24V to the motors
and clutches.
Refer to Wiring Diagram 4
1. Make sure that the toner cartridge is not empty. If necessary, install a new toner cartridge,
PL 9.10 Item 2.
2. Enter dC330 code 09-600 and 09-700. Check that the toner dispense motor (MOT09-
600), PL 4.20 Item 3 runs and deactuates the toner sensor (Q09-700).
NOTE: It may be necessary to enter the codes several times to ensure that the toner dis-
pense motor deactuates the toner sensor. It may also be necessary to make several cop-
ies to prevent over toning the xerographic module.
3. Remove the toner cartridge,
Enter dC330 code 09-600. Make sure that the toner dispense motor runs and drives the
toner dispense idler gear,
ponents as necessary,
4. Check the wiring between the toner dispense motor and CN9 on the
5. Check the wiring between the xerographic module connector,
on the Main PWB. If necessary, install a new xerographic module connector,
17.
6. If necessary, install a new xerographic module,
7. Perform the OF5 Main PWB Check RAP.
January 2016
2-63
WARNING
and Wiring Diagram 5. Perform the following:
PL 9.10 Item 2 and xerographic module,
PL 4.20 Item 7 and coupling, PL 4.20 Item
PL 4.20.
PL 9.10 Item 1.
Main
PL 9.10 Item 1.
9. Install new com-
Main PWB.
PL 4.15 Item 17 and CN11
PL 4.15 Item
Status Indicator RAPs
09-100, 09-200