Xerox WorkCentre 4150 Service Manual page 211

REP 1.6 Power Supply Unit 2 (4250/4260)
Parts List on PL 1.15
Removal
NOTE: This procedure should only be performed on the 4250/4260. For the 4150 procedure,
refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Power off the machine. Disconnect the power cord.
2. Remove the exit tray assembly, PL 28.10 Item 1
3. Remove the paper exit cover, PL 28.10 Item
4. Remove tray 1.
5. Remove the toner cartridge, PL 9.10 Item 2
6. Remove the front door assembly, Figure
Repairs and Adjustments
REP 1.6
WARNING
WARNING
CAUTION
GP
or the finisher, REP 12.1.
4.
then the xerographic module, PL 9.10 Item
1.
10.
1.
1
Remove 4 screws, then the front door assembly.
7. Remove the front infill cover,
8. Remove the power supply cover,
9. Disconnect the following connectors from power supply unit 2:
• CON1
• CON2
• CON3
• CON4
10. Remove power supply unit 2,
January 2016
4-10 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
Figure 1 Front door removal
PL 28.10 Item 9.
PL 1.15 Item 21.
Figure 2.