Rep 8.4 Speaker; Rep 8.5 Bypass Tray Retard Assembly - Xerox WorkCentre 4150 Service Manual

REP 8.4 Speaker

Parts List on PL 7.17
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the paper transport assembly,
2. Remove the speaker, Figure 1.
2
Remove 2 screws, then
the speaker.
Figure 1 Speaker Removal
Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 8.4, REP 8.5
WARNING
WARNING
CAUTION
GP
REP 8.3.
1
Disconnect the inline connector

REP 8.5 Bypass Tray Retard Assembly

Parts List on PL 8.20
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
10. Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the main drive assembly, (4150)
2. Remove the side cover assembly,
3. Remove the bypass tray retard assembly,
4. If necessary, remove the retard pad,
Replacement
Replacement is the reverse of the removal procedure. If a new retard assembly is installed,
reset the HFSI count to zero. Go to
January 2016
4-136 WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
REP 4.1 or (4250/4260/4265)
REP 8.1.
Figure 1.
1
Remove 1 screw, then
the bypass tray retard
assembly
Figure 1 Removal
PL 8.20 Item 4.
GP 16 High Frequency Service Items.
GP 10.
REP 4.3.