Xerox WorkCentre 4150 Service Manual page 331

10. Prepare the rear of the registration roll,
2
Remove the E-clip.
Figure 2 Preparation
11. Prepare the front of the registration roll,
1
Remove the E-clip, then the
bearing.
Figure 3 Preparation
Repairs and Adjustments
REP 8.2
Figure 2.
1
Remove the E-clip,
then the bearing.
Figure 3.
12. Remove the registration roll cover,
13. Remove the actuator assemblies,
Figure 5 Actuator Assembly Removal
14. If necessary, remove the duplex jam 2 sensor actuator assembly,
January 2016
4-130 WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
Figure 4.
1
Remove 2 screws.
2
Unclip, then remove the
registration roll cover.
Figure 4 Cover Removal
Figure 5.
1
Unclip, then remove both actuator
assemblies.
PL 8.15 Item 15.