Rep 10.7 Fuser Assembly Components (4250/4260/4265) - Xerox WorkCentre 4150 Service Manual

Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 10.6, REP 10.7

REP 10.7 Fuser Assembly Components (4250/4260/4265)

Parts List on PL 10.28 and
Purpose
This procedure is used to repair the following components:
NOTE: Only perform the steps that are necessary to repair the damaged component.
• Springs, PL 10.28 Item 7.
• Heat lamp assembly, PL 10.30 Item
• Heat roller, PL 10.30 Item
• Heat roller collar, PL 10.30 Item
• Heat roller bearings, PL 10.30 Item
• Pressure roller bearings, PL 10.30 Item
• CRUM Assembly PL 10.28.
Removal
NOTE: This procedure should only be performed on the 4250/4260/4265 machines. For the
4150 procedure, refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not touch the fuser while it is hot.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the Fuser Assembly
January 2016
4-156 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
PL 10.30
13.
10.
9.
8.
17.
WARNING
WARNING
CAUTION
(REP 10.1).
GP 10.