Rep 9.4 Xerographic Module Connector (4250/4260) - Xerox WorkCentre 4150 Service Manual

Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 9.3, REP 9.4

REP 9.4 Xerographic Module Connector (4250/4260)

Parts List on PL 4.15
Removal
NOTE: This procedure should only be performed on the 4250/4260. For the 4150 procedure,
refer to the table of contents.
For the 4265 procedure, refer to
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the main drive assembly,
2. Remove the xerographic module connector,
4
Carefully disconnect the connector.
January 2016
4-142 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
REP 9.6
WARNING
WARNING
CAUTION
REP 4.3.
Figure 1.
3
Remove the xerographic
module connector.
2
Remove the connector
holder.
1
Remove 4 screws.
Figure 1 Connector removal
GP 10.