Rep 14.3 Scanner Assembly (4250/4260/4265) - Xerox WorkCentre 4150 Service Manual

REP 14.3 Scanner Assembly (4250/4260/4265)

Parts List on PL 14.13, PL 14.16
Removal
NOTE: This procedure should only be performed on the 4250/4260 and 4265 machines. For
the 4150 procedure, refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the DADF. Refer to REP 5.3.
2. Remove the rear cover, PL 28.10 Item
3. Disconnect CN1, CN2, CN3 and CN6 from the main PWB.
4. Remove the three Scanner mounting screws from the rear of the machine
Figure 1 Removing the Scanner Assembly Mounting Screws
5. Open the side cover assembly, PL 7.30 Item
Item 2.
6. Remove the toner cartridge, PL 9.10 Item 2
7. Remove paper tray 1.
8. Remove the exit tray assembly, PL 28.10 Item 1
9. Remove the paper exit cover, PL 28.10 Item
Repairs and Adjustments
REP 14.3
WARNING
WARNING
CAUTION
GP
6.
(Figure
1
Remove the three
mounting screws.
1, then the front door assembly,
then the xerographic module, PL 9.10 Item
or the finisher, REP 12.1.
4.
10. Remove the front door assembly
10.
1).
1
Remove 4 screws, then the front door
assembly.
PL 28.10
1.
January 2016
4-186 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
(Figure 2).
Figure 2 Removing the Front Door Assembly