Xerox WorkCentre 4150 Service Manual page 76

01-100 Side Cover Assembly Open RAP
01-100 The machine has detected that the side cover assembly is open. When the cover is
open, there is no +24V supply to the motors or the HVPS.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Go to the relevant procedure:
• 4150 Checkout
• 4250/4260/4265 Checkout
4150 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the
PWB PJ location illustration.
Refer to Wiring Diagram 4 and Wiring Diagram
1. Switch off the machine, then switch on the machine.
2. Check that the interlock switch actuator on the side cover assembly,
missing or damaged.
3. Check that the side cover assembly closes correctly.
4. Enter dC330 code 01-100. Check the side cover interlock switch assembly (S01-100),
4.15 Item 12.
5. Check the wiring between the side cover interlock switch and CN8 on the
necessary, install a side cover interlock switch assembly,
6. Check for +24V between CON71 on
necessary, install a new power supply unit 1,
7. Perform the OF5 Main PWB Check RAP.
4250/4260/4265 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the
PWB PJ location illustration.
Refer to (4250/4260) Wiring Diagram 17
Wiring Diagram 38.
1. Switch off the machine, then switch on the machine.
2. Check that the interlock switch actuator on the side cover assembly,
missing or damaged.
3. Check that the side cover assembly closes correctly.
4. Enter dC330 code 01-100. Check the side cover interlock switch assembly (S01-100),
4.15 Item 12.
5. (4250/4260) Check the wiring between the side cover interlock switch and CN9 on the
Main PWB. If necessary, install a side cover interlock switch assembly,
6. Check for +24V between CON71 on
necessary, install a new power supply unit 1,
7. (4265) Check the wiring between the side interlock sensor and CN 18 on the
necessry, install a side cover interlock switch assembly,
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
8. Perform the following:
PL 7.30 Item 1
PL 4.15 Item 12.
Power Supply Unit 1 and CN27 on the
PL 1.10 Item 3.
and Wiring Diagram 22, (4265) Wiring Diagram
PL 7.30 Item 1
PL 4.15 Item
Power Supply Unit 1 and CN27 on the
PL 1.15 Item 3.
PL 4.15.
8. Check for +24V between CON71 on
necessary, install a new power supply unit 1,
9. Perform the OF5
Main
is not
PL
Main PWB. If
Main PWB. If
Main
33and
is not
PL
12.
Main PWB. If
Main PWBIf
January 2016
2-3
Power Supply Unit 1
PL 1.15 Item
Main PWB Check RAP.
and CN33 on the Main PWB. If
3.
Status Indicator RAPs
01-100