Xerox WorkCentre 4150 Service Manual page 212

Figure 2 Power supply unit 2 removal
11. Remove power supply 2 from the support cage,
Replacement
Replacement is the reverse of the removal procedure.
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
2
Disconnect the
inline connector.
3
Remove power
supply unit 2.
1
Remove 2 screws.
PL 1.15 Item 10.
January 2016
REP 1.7 HVPS (4265)
Parts List on PL 1.15, PL 1.20
Removal
NOTE: This procedure should only be performed on the 4265. For the 4250/4260 procedure,
refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
electrical outlet while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Power off the machine. Disconnect the power cord.
2. Remove the Exit Tray Assembly,
3. Remove the Paper Exit Cover
4-11
WARNING
WARNING
CAUTION
PL 28.10 Item 1 or the finisher, REP 12.1.
(PL 28.10 Item 4).
Repairs and Adjustments
REP 1.6, REP 1.7
GP 10.