7.15 Tray 1 Frame Assembly (1 Of 2) - Xerox WorkCentre 4150 Service Manual

PL 7.15 Tray 1 Frame Assembly (1 of
2)
Item Part Description
1 130N01560 Paper size detect assembly
(4250/4260/4265)
– 130N01460 Paper size detect assembly (4150)
(REP 7.3)
2 130N01274 Tray 1 home position sensor
(Q07-100), Tray 1 paper low sensor
(Q07-160)
3 – Harness (P/O
4 – Housing (P/O
5 140N63404 Paper size detect PWB
(4250/4260)
– 130N01461 Paper size detect PWB
(4150/4265)
6 – Grounding strip (P/O
1)
7 – Sensor harness (Not Spared)
8 127N07488 Tray 1 elevating motor
(MOT04-510)
9 007N01531 Tray 1 feed gear
10 007N01532 Retard roll gear
11 – E-Clip (Not Spared)
12 – E-Clip (Not Spared)
13 007N01498 Pick-up gear
14 – Bearing (P/O
15 022N02230 Retard assembly
16 – Drive shaft (P/O
17 – Actuator (P/O
18 006N01299 Retard shaft
19 006N01293 Pin
20 022N02232 Retard roll assembly
21 022N02231 Drive dog coupling
22 017N00259 Drive dog
23 – Retard bracket (P/O
15)
24 – Tray feed assembly (REF:
Item 1)
25 – Not used
26 – Right hand base (REF:
(Not Spared)
27 – Not used
28 – Casette (REF:
29 – Rear panel (Not Spared)
30 005N01139 Pick-up clutch (CL08-810)
(4250/4260/4265)
– 005N01085 Pick-up clutch (4150)
31 – K-L Clip (Not Spared)
32 152N11765 Tray connector (4250/4260/4265)
33 009N01596 Spring
34 – Feed assembly spring (REF:
8.10 Item
NOTE: 1. Roll Assy shipped one Roll per bag. CSE must
order three: Nudger Roll, Feed Roll, and Retard Roll. 2. Tray
Connector (Item32) is compatible with 4150, so long as the
included Wire Harness is removed. (Use the old Wire Har-
ness currently on the machine.)
WorkCentre 4150/4250/4260WorkCentre 4150/4250/4260/4265WorkCentre
(REP 7.3)
PL 7.15 Item 1)
PL 7.15 Item 1)
(REP 7.3)
(REP 7.3)
PL 7.15 Item
PL 7.15 Item 15)
PL 7.15 Item 15)
PL 7.15 Item 15)
PL 7.15 Item
PL 8.10
PL 7.17)
PL 7.10)
PL
16)
January 2016
Parts List
PL 7.15