Rep 12.3 Transport Assembly Components - Xerox WorkCentre 4150 Service Manual

REP 12.3 Transport Assembly Components

Parts List on PL 12.20
Purpose
This procedure is used to repair the following components:
NOTE: Only perform the steps that are necessary to repair the damaged component.
• Exit Sensor, PL 12.20 Item 7.
• Exit Roll, PL 12.20 Item 1.
• Drive belt, PL 12.20 Item 12.
• Paper Detector Sensor, PL 12.20 Item
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the Finisher, REP 12.1.
2. Remove the Finisher covers, REP
3. Remove the Paddle Motor and bracket,
4. Remove the Exit Belt cover, PL 12.10 Item
5. Remove the Exit Cover, PL 12.10 Item
6. If necessary, remove the Exit Sensor,
7. Disconnect the Exit Sensor bulkhead connector. Remove the upper exit guide,
Item 2.
8. Remove the Lower Exit Guide, PL 12.20 Item
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
25.
WARNING
WARNING
CAUTION
GP
12.4.
PL 12.30 Item 5.
20.
6.
PL 12.20 Item 7.
9.
9. Prepare to remove the Exit Roll
10.
PL 12.20
January 2016
4-167
(Figure 1).
3
Remove the E-clip
then the bearing.
2
Remove the E-clip
then the pulley.
1
Remove the drive
belt.
Figure 1 Preparing to Remove the Exit Roll
Repairs and Adjustments
REP 12.3