Rep 12.4 Finisher Covers - Xerox WorkCentre 4150 Service Manual

10. Remove the Exit Roll (Figure 2).
Figure 2 Removing the Exit Roll
11. If necessary, remove the Paper Detector Sensor,
Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 12.3, REP 12.4
2
Remove the Exit Roll.
1
Remove the E-clip
then the nylon bearing.
PL 12.20 Item 25.
January 2016

REP 12.4 Finisher Covers

Parts List on PL 12.10
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the Finisher, REP 12.1.
2. Remove the Staple Cartridge,
3. Remove the Top Infill Cover, PL 12.10 Item
4-168 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
PL 12.35 Item 4.
5.
GP 10.