Xerox WorkCentre 4150 Service Manual page 274

7. Disconnect the two connectors (Figure
1
Disconnect the Drive Roll
Motor connector.
Figure 4 Disconnecting the Connectors
WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
4).
2
Disconnect the connector.
8. Remove the Harness Holder
1
Open the two wire clips and remove the wires.
Harness Holder
Figure 5 Removing the Harness Holder
January 2016
4-73
(Figure 5)
2
Remove the two mounting screws and
remove the Harness Holder.
Repairs and Adjustments
REP 5.19