Xerox WorkCentre 4150 Service Manual page 226

REP 2.6 User Interface Assembly (4265)
Parts List on PL 2.14
Removal
NOTE: This procedure should only be performed on the 4265. For other configurations, refer
to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Power off the machine. Disconnect the power cord.
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
GP
2. Remove the User Interface Inlay
10.
1
Use a flat-blade
screwdriver to
carefully lift the
front lower corners
of the UI inlay.
January 2016
4-25
(Figure 1).
2
Lift and remove the UI Inlay from the machine.
Figure 1 Removing the User Interface Inlay
Repairs and Adjustments
REP 2.6