4.
Separate the Fuser Assembly
(Figure
1
Remove 2 springs.
2
Remove the 2 screws
marked A.
Figure 3 Separating the Fuser Assembly
Repairs and Adjustments
REP 10.7
3).
3
Carefully separate the
fuser assembly.
Do not damage the Fuser Stripper Fingers when removing the Heat Roll Assembly.
5.
Remove the Heat Roll Assembly and components
Stripper fingers
(4 off).
2
Remove the front bear-
ing, then the collar.
Figure 4 Removing the Heat Roll Assembly
January 2016
4-158
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
CAUTION
(Figure
4).
3
Release the spring
clip, then remove the
drive roller.
4
Remove the rear bearing, then
the collar.
1
Carefully remove the heat
roller assembly.