Installing Endless Draper - MacDon D65 Operator's Manual

6.7.5 Installing Endless Draper

To install an endless draper, follow these steps:
DANGER
To avoid bodily injury or death from unexpected
start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going
under header for any reason. Refer to the windrower
operator's manual for instructions regarding the
proper use and storage of header safety props.
1. Insert a pry bar (A) through draper and locate bar
in hole in deck located at approximately the deck
mid-point.
NOTE:
Pry bar should be sufficient length to
accommodate width of draper.
2. Lift deck clear of cutterbar and support bar on a
stand (B) of suitable height.
3. Slide draper onto deck.
4. Lift deck, remove stand (B), and lower deck into
position. Remove pry bar (A).
169899
MAINTENANCE AND SERVICING
Figure 6.115: Supporting the Draper
Figure 6.116: Lifting the Deck
183
Revision A