MacDon D65 Operator's Manual page 206

Installing Draper Drive Roller
1. Locate the drive roller (B) between the roller
support arms.
2. Install bolt (A) that holds the drive roller to the arm
closest to the cutterbar.
(95 N·m).
3. Grease motor shaft and insert into the end of the
drive roller.
4. Secure motor to the roller support with four bolts (A).
Torque to 20 ft·lbf (27 N·m).
NOTE:
Tighten any loosened bolt and reinstall plastic shield (B),
if removed.
5. Tighten the two set screws through access hole (C).
6. Wrap the draper over the drive roller, and attach ends
of draper with tube connectors (B), screws (A) with
heads facing the center opening, and nuts.
169899
MAINTENANCE AND SERVICING
Torque bolt to 70 ft·lbf
194
Figure 6.138: Drive Roller
Figure 6.139: Drive Roller
Figure 6.140: Draper Connector
Revision A