MacDon D65 Operator's Manual page 72

Reposition right arm cylinder as follows:
NOTE:
Reel components are not shown for clarity.
1. Position reel fully aft with support arms horizontal.
2. Stop engine and remove key.
3. Remove four bolts (A) securing cylinder bracket (B) to
reel arm.
4. Push reel back until bracket (B) lines up with the aft set
of holes (C).
5. Reinstall the four bolts (A) to secure bracket to reel arm
at new position.
169899
OPERATION
Figure 4.32: Right Arm Cylinder - Forward
Position
Figure 4.33: Right Arm Cylinder - Rearward
Position
60
Revision A