Break-In Inspection - MacDon D65 Operator's Manual

Maintenance
Action:
Record
Upper Cross Auger RH

Bearing
250 HOURS OR ANNUALLY
 Draper Seal
Upper Cross Auger Center

Support and U-Joint
 Reel Drive U-joint
Transport Axle Pivot

Bushings
500 HOURS OR ANNUALLY
 Draper Seal
 Reel Shaft Bearings
Stabilizer/Slow Speed

Transport Wheel Bearings
1000 HOURS OR 3 YEARS
▲ Knife Drive Box Lubricant

6.3.2 Break-In Inspection

A break-in inspection includes checking belts, fluids, and a general machine inspection for loose hardware or other
areas of concern. The break-in inspection ensures that all components can operate for an extended period
without requiring service or replacement.
Timing
Check for loose hardware.
Tighten to required torque.
At 5 hours
Check knife drive belts tension.
Periodically check for first 50 hours.
Check knife drive box mounting
At 10 hours
bolts.
At 50 hours Change knife drive box lubricant.
169899
MAINTENANCE AND SERVICING
 - Check
15
15
15
Item
 - Lubricate
6.2.3 Torque Specifications, page 115
Tensioning Timed Knife Drive Belts, page 168
Tensioning Non-Timed Knife Drive Belts, page 163
Mounting Bolts, page 153
Changing Oil in Knife Drive Box, page 161
130
▲ - Change
Refer To
Revision A