MacDon D65 Operator's Manual page 189

1. Apply talc (baby powder) or talc/graphite lubricant mix
to the draper surface that forms the seal with the cutter
bar and to the underside draper guides.
2. Insert draper into deck at outboard end, under the
rollers. Pull draper into deck while feeding it at the end.
3. Feed in the draper until it can be wrapped around the
drive roller.
4. Similarly, insert the other end into the deck over the
rollers. Pull draper fully into the deck.
5. Loosen the rear deck deflector (A) by loosening
mounting bolts
draper installation.
6. Attach ends of draper with tube connectors (B),
screws (A) with heads facing the center opening,
and nuts.
7. Adjust tension. Refer to
Tension, page 178.
169899
MAINTENANCE AND SERVICING
(B). This may help
6.7.3 Adjusting Draper
Figure 6.102: Installing Draper
with
Figure 6.103: Backsheet Deflector
Figure 6.104: Draper Connector
177
Revision A