Removing Plastic Fingers - MacDon D65 Operator's Manual

IMPORTANT:
Ensure tine tube is supported at all times to prevent damage to the tube or other components.
1. Slide new tines and reel arm (A) onto end of tube.
2. Install tine tube bushings. Refer to
207.
Bushings, page
3. Attach tines to tine bar with bolts and nuts (B).

Removing Plastic Fingers

WARNING
To avoid bodily injury from fall of raised reel, always
engage reel safety props before going under raised
reel for any reason.
1. Remove screw (A) with a Torx
socket wrench.
2. Push finger top clip back toward reel tube and remove
from finger tube.
169899
MAINTENANCE AND SERVICING
6.8.5 Tine Tube
Figure 6.164: Tine Tube
®
Plus 27 IP
Figure 6.165: Removing Finger
Figure 6.166: Removing Finger
206
Revision A