Installing Endless Draper - MacDon D65 Operator's Manual

6.7.5 Installing Endless Draper

To install an endless draper, follow these steps:
DANGER
To avoid bodily injury or death from unexpected
start-up or fall of raised machine, always stop
engine, remove key, and engage safety props
before going under header for any reason. See
your windrower operator's manual for instructions
for use and storage of header safety props.
1. Insert a pry bar (A) through draper and locate bar
in hole in deck located at approximately the deck
mid-point.
NOTE: Pry bar should be sufficient length to
accommodate width of draper.
2. Lift deck clear of cutterbar and support bar on a
stand (B) of suitable height.
3. Slide draper onto deck.
4. Lift deck, remove stand (B), and lower deck into
position. Remove pry bar (A).
169594
MAINTENANCE AND SERVICING
186
Figure 6.131
Figure 6.132
Rev. C