6.2.2 Recommended Fluids and Lubricants
Your machine can operate at top efficiency only if clean lubricants are used.
• Use clean containers to handle all lubricants.
• Store in an area protected from dust, moisture, and other contaminants.
Lubricant
Specification
SAE
Grease
Multi-Purpose
Gear
SAE 85W-140
Lubricant
6.2.3 Torque Specifications
The following tables give correct torque values for various bolts, cap screws, and hydraulic fittings.
• Tighten all bolts to the torques specified in chart (unless otherwise noted throughout this manual).
• Replace hardware with the same strength and grade bolt.
• Check tightness of bolts periodically, using the tables below as a guide.
• Torque categories for bolts and cap screws are identified by their head markings.
SAE Bolt Torque Specifications
Torque values shown in this table are valid for non-greased, or non-oiled threads and heads. Therefore, do NOT
grease or oil bolts or cap screws unless otherwise specified in this manual.
Table 6.1 SAE Grade 5 Bolt and Grade 5 Free
Spinning Nut
Torque (ft·lbf)
Nominal
(*in·lbf)
Size (A)
Min.
1/4-20
*106
5/16-18
*218
3/8-16
32
7/16-14
52
1/2-13
79
9/16-12
114
5/8-11
157
281
3/4-10
7/8-9
449
1-8
611
169899
MAINTENANCE AND SERVICING
Description
High
Temperature
Pressure (EP2) Performance
With 1% Max.
Molybdenum
Disulphide (NLGI Grade 2)
Lithium Base
API Service Class GL-5
Torque (N·m)
Max.
Min.
Max.
*117
11.9
13.2
*241
24.6
27.1
36
44
57
70
87
106
118
126
153
170
173
212
234
311
380
420
496
606
669
676
825
912
Use
Extreme
As Required Unless
Otherwise Specified.
Knife Drive Box
Main Drive Gearbox
48
77
Figure 6.1: Bolt Grades
A - Nominal Size
C - SAE-5
115
Capacities
—
2.3 quarts (2.2 liters)
5 pints (2.5 liters)
B - SAE-8
D - SAE-2
Revision A