MacDon D65 Operator's Manual page 171

®
4. Apply Loctite #243 to the output shaft in two bands as
shown at (A).
5. Slide output arm (B) onto output shaft. Rotate pulley to
ensure drive arm just clears frame on inboard stroke to
ensure proper placement on splines.
6. Position output arm (A) to farthest outboard position.
Move output arm (A) up or down on splined shaft until
it almost contacts knifehead (B). Exact clearance (C)
will be set when installing knifehead pin.
7. Torque output arm bolt (B) to 160 ft·lbf (217 N·m) to
secure arm to knife drive output shaft.
169899
MAINTENANCE AND SERVICING
Figure 6.62: Knife Drive Box
Figure 6.63: Knifehead
Figure 6.64: Knife Drive Box
159
Revision A